Specification Power Amp AXL Audion A-10 DSP










Specification:
Model Characteristic H-35 A-2 A-3 A-6 A-8 A-10 A-12
Out Power ( 8 Ohm ) 2 x 350w   2 x 200w  2 x 300w 2 x 600w 2 x 800w 2 x 1000w 2 x 1200w
Out Power ( 4 Ohm ) 1x700w 8ohm 2 x 350w 2 x 500w 2 x 1050w 2 x 1350w 2 x 1700w 2 x 1900w
Out Power ( 2 Ohm ) 2 x 550w 2 x 500w 2 x 800w 2 x 1400w 2 x 1800w 2 x 2200w 2 x 2400w
Out Power ( BRIDGE ) 8 Ohm 1x1000w  650w 1000w 1750w 2300w 2900w 3000w
Out Power ( BRIDGE ) 4 Ohm 4 ohm 950w 1300w 2300w 2900w 3800w 4000w
THD+Noise@1Khz Full Power < 0.03 % < 0,035 %
IMD 60 Hz & 7 Khz, 4 : 1 < 0.038 % < 0,04 %
Signal to noise Ratio > 102dB > 105dB
Output Circuit type Class AB Class H
Input Sensitivity na Selectable ( 0,77 V / 1,0V / 1,44V )
Output Connectors 3 binding post 4 Pole Speakon & Binding posts
Panel Controls na Front-2 input attenuators REAR-Ground lif, mode selection, compressor
Frequency Response  15Hz - 25Khz(+0/-1dB)
Slew Rate ( input filter limited ) 40 V / uS
Damping Factor 1Khz@8 Ohm > 400 : 1
Input Impedance 10K Ohm Balanced to Ground
Input Connectors Female XLR - 3 & 6,35mm TRS Jack
Protections Full short-circuit,Open-circuit,Thermal,Soft-start,DC voltage, Sub/Ultrasonic and RF
Led Indicators ( per Channel ) Active, Signal, Limit, Protect
Cooling Front to back via 2 variable speed fans
Advertisemet
Share on Google Plus

0 komentar:

Posting Komentar